Three Phase resetBattery reset?
Whether at the contactor or at the motor terminals, you have the three phase wires at the contactor relay, as said, just swop two over job done.I would swap over any 2 of the wires going to the contactor relay as circled. Isolate power first of course.
Keep us all posted please and to see who had the correct answers for your setupTrying to get hold of him as I know it will take seconds to sort out.
He's coming first thing tomorrow morning.
Which was why I said at the switch. Should have said I meant at motor. Not panel!! Duh.This, or I would look at doing it either at the motor or at the mains supply to the main circuit breaker. The rest of the panel won’t care about the phase rotation and the motor will go the other way.
And to know you haven’t fried yourself!Keep us all posted please and to see who had the correct answers for your setup
They did show me it was wired up but said it didn't go up because I haven't got the cables tensioned right.if he's an electrical he would know and have checked phase rotation just change any two a round on the incoming to the switch
Keep us all posted please and to see who had the correct answers for your setup
I bought an AliExpress rotation meter, afterwards. 30 bucks. The company that was doing the work was the highest bidder... And i thought responsible. According to them the phases were inverted when they entered the premises.. Like that was an excuse..if he's an electrical he would know and have checked phase rotation just change any two a round on the incoming to the switch
Then they should have disconnected the motor drive and turned the motor over to prove it was working.They did show me it was wired up but said it didn't go up because I haven't got the cables tensioned right.
I have since removed the 4 arms and cables and everything was right.
The lift manufacturers confirmed it was the wiring.
The owner of the company is coming in the morning so we will see what he says.
Local to our village so I don't want to fall out that's for sure living in a old property.
We just jag our motors here prior to final connection to ascertain rotation direction.