Search results

Hi Gents, Apologize if this had been discussed in another thread. Recently I purchased a left and right rear lower control arms for my 1999 3200GT from Eurospares and the garage told me they are not the same as the old ones. Please see photos attached if they are actually difference or...

Hi Gents, Indie informed me that my rear left control arm and front lower level wishbone (Assy) are getting loose so might not pass MOT. I guess the control arm itself should be fine unless the metal is cracked so replacement of Ball Joint Gaiter should be ok...

Hi Gents, Clutch was slippery so ordered a set of 3 pieces from Holland. Just wonder if this is a big job with engine out. What is the estimated labour cost from your experience? And if I should take care of other things as well while this job is performed? Many thanks for your help again

Morning gents, Recently car stowed from time to time if the air-con is on when I press the clutch. Doesn't matter if the engine is cold or hot. No such issue if aircon is not being switched-on. Knock sensors changed one year ago. Checked with data cable with the computer and there is...

Please PM me if you are willing to ship to the other side of the globe Thanks

Morning gents, Anyone encounters or knows what is this error code for?

Morning Gents, Got the car back from the indie two days ago After water pump exchange and window regulators alignment. The car seems playing on cold start. Idle rpm sometime at 1300 but back to Normal after a few minutes. Acceleration from 1st & 2nd gear seem fine but jerky at 3rd...

Morning Gents, Hope all of you had a great weekend. I reckon some of you did mention the Windows regulators of the 3200GT is the same as the Alfa 916 GTV. Just wonder if anyone actually tried and got one from 916GTV and installed on the 3200GT. I was told by the Indie that the 3200GT...

Hi gents, Mechanic informed me the clutch is start slipping especially driving hard. Should I get the whole clutch kit (Eurospares $1,460.00 pounds)? Or could I ask the mechanic to check and locate the actual part (clutch cover, disc or bearing) actually needed to be replaced? Many...

Hi Genta, Mechanic told me the water pump is leaking. Could I just get the pump itself or need the whole one with housing?

Hi All, Garage informed me that I might need to order the Power steering box soon although they reckon it is ok to tightening up at the moment for MOT. It is no 14 in Eurospares picture. I also realize the tie rod ends could be purchased separately but is there any alternative not to purchase...

Hi Gents, Found blue/greenish coolant on the ground yesterday and floor is still wet after refill. I had the cambelt changed by an independent garage 2 weeks ago. Checked on the net and someone reckons: "Radiator top flange tends to crack around the base, usually due to someone moving or...

Good day everyone! Car in absolute limp mode in a hot far east summer at 35 degree c and suddenly CEL on and can only go up to 1000-1200rpm Hook up to computer and get the error codes attached. Throttle body been refurnished and Throttle poentiometer disconnected and cleaned in 2012 but...

Hi Gents, Windows life/drop queries. Symptoms: 1. Driver side Open door from outside, window won't drop(most of the time), has to lower the window a bit using switch inside so door could be closed without blockage by window Open door from inside, window won't drop (most of the time)...

Hi All, Please do not laugh in case it is a stupid question. Just wonder if the Fiat 3-pin to OBDII cable and the following would allow it to read and clear the error code of those 1998-2000 pre-OBDII standard 3200GT...

Hi all, Newbie to here and 3200GT but ex-owner of Ghibli 2.8, QP IV and 4200GT. All of the previous Maseratis owned are auto or F1 so really look forward to enjoying the 6-speed manual 3200GT Questions for all you experienced owners please. 1. Anyone has the owner's manual in...