Oneball
Member
- Messages
- 11,129
I assumed that was why the tube of grease was included - its a nice fit on mine so not intending to remove paint
The pic is as close together as the two halves of the mounts will go on mine.
I assumed that was why the tube of grease was included - its a nice fit on mine so not intending to remove paint
Thanks Dave, I’ll give them a ring about the nuts. What’s the name of the company?
Spoke to Niko at Cornering Force
He says the clamps will be tight on bar and will bed in over a short time, put them on with the supplied grease and clamp up.
He is going to re-manufacture the nuts to the correct size, M10x1.25 which is what I've measured on mine, can someone double check? They are a custom job so it may take some time, I'm not sure whether there will be a cost associated with this.
He still has the one to go to Holland (I think) so he might keep that back until new nuts are ready.
Couple of pics for Dave as he’s not seen one.
View attachment 53849View attachment 53850
Yes, there's one roll bar kit left, I can give them a call if you wantHi Dave, reading the thread I saw that you wrote there was still one set lett. If that is the case I am interested. Can you let me know?
Dave, thanks for coming back and yes, definitely interested if the kit is still available. I live in The Netherlands so hope sending it over here is not an issue?
Regards,
Adrian