GS Headlight problem

[YHTM]

My main beam headlights have stopped working, full beam is fine as are all the other lights.

It has been suggested that the stalk unit is faulty so I have ordered a new one from Eurospares - anyone come across this fault before?

 

[Geofflyn]

My main beam headlights have stopped working, full beam is fine as are all the other lights.

It has been suggested that the stalk unit is faulty so I have ordered a new one from Eurospares - anyone come across this fault before?

Did you by any chance fit an Alfa stalk unit to get cruise control? I haven't heard of it being a problem but just wondered.
Geoff

 

[lozcb]

My main beam headlights have stopped working, full beam is fine as are all the other lights.

It has been suggested that the stalk unit is faulty so I have ordered a new one from Eurospares - anyone come across this fault before?

Time to get the tweezers out and check all the fuses i reckon



regards loz

 

[conaero]

Usual issues with the headlighs if they are Xenons is one of them intermittently stops working. This is due to a bad joint on the transformer.

If both have gone out and you have checked the fuses then your assumption is logical.

 

[conaero]

Usual issues with the headlighs if they are Xenons is one of them intermittently stops working. This is due to a bad joint on the transformer.

If both have gone out and yu have checked the fuses then your assumption is logical.

 

[YHTM]

Did you by any chance fit an Alfa stalk unit to get cruise control? I haven't heard of it being a problem but just wondered.
Geoff

No, still the original unit. Fuses checked so it's going to have to be the unit replaced next.
Any idea where I can find a wiring chart for the stalk?

 

[YHTM]

This is now getting annoying!
The connection between the low beam relay and the lights is fine, the problem appears to be between the switch and the relay. Does anyone know if there is a control unit between these two?
Matt has been really helpful sending some diagrams but the headlight wiring is not there - any help will be massively appreciated!

 

[Jburris]

I’ve got the same issue, did you ever figure yours out? I know this is an old thread. From the partial wiring diagram I have, it looks like the relay power comes from some module.