Zep's latest activity

I dunno C; I was concerned when I started the thread and I'm totally befuddled now. Joered posts a picture of some woman covered in...

Its a shame because Rick's videos are usually quite good, but it is mostly about how hard it is to do the cam timing.

I was going to post it, but it didn't go into too much detail and engine is *******!

They put it there to reduce the high pressure area under the wheel arch. Reduces drag, goes faster.

Tremendous work from National windscreens. I was slightly nervous about such a general outfit but I needn’t had worried. They sent their...

If you choose the MP route, remember you have to take your own orange on the first day.

I am a member of an internet car forum where activities seem, shall we say, a little unconventional; one member declares that he is off...

How does Bob Marley like his doughnuts ? Wi' Jammin'

While I haven’t needed to get a COC, I have dealt with the factory for various things and have always found them very helpful. The...

Good of you to say so, thanks! :)

Couldn't agree more. Still chuffed at doing the SKF rear track-rod bearings replacement on the MCV. Your help, with very clear...

That I did not know, any idea which dates?

Welcome. A lot of people here do their own spannering. On the most part, with the assistance of experience on here, there isn’t much...

You need a tool which can talk to the TCU, there are lots, like EasyMas, but they are not generally kept by non- specialists. There are...

The Clutch Wear reading is derived from the Clutch Position Sensor which is extremely accurate. Inaccurate Clutch Wear values are down...