spacecadet
Member
- Messages
- 378
After doing all the above I've replaced the oil too and requested an oil analysis as suggested at the beginning of this thread. The sample was collected after driving 200km (not high speed, not above 4000 RPM). Selenia Racing was never checked by the company so far, but what they found quite strange:
- no fuel found, at least
- viscosity on 40C: 115 instead of 187.5
- viscosity on 100C: 17.9 instead of 23
- major amount of Silicon (35 ppm), this could be my direct air filter or also anti-foaming additive in the oil
Since I didn't drive hard the thinning cannot be because of shearing and fuel also wasn't found maybe it's an issue with the quality of the oil? I might send off some unused oil from the can to check that too.
- no fuel found, at least
- viscosity on 40C: 115 instead of 187.5
- viscosity on 100C: 17.9 instead of 23
- major amount of Silicon (35 ppm), this could be my direct air filter or also anti-foaming additive in the oil
Since I didn't drive hard the thinning cannot be because of shearing and fuel also wasn't found maybe it's an issue with the quality of the oil? I might send off some unused oil from the can to check that too.