Yaw rate sensor location

Pgp340

New Member
Messages
17
I finally resolved the soft suspension issue. Amazing how inept the dealer was. The problem was the ride height.
Now it’s just fine and very driveable.
I also replace the sway bars with FOrmula Dynamics and it’s much much better.
Another issue I have is the air bag light that won’t go off.

repalced airbag…no change
replaces airbag ecu…no change

could it be the Digitek box under the dash ? And if buy a used on does it matter if I games from a car that the speedo is in km/h or miles/h ?
 

spkennyuk

Member
Messages
5,983
I finally resolved the soft suspension issue. Amazing how inept the dealer was. The problem was the ride height.
Now it’s just fine and very driveable.
I also replace the sway bars with FOrmula Dynamics and it’s much much better.
Another issue I have is the air bag light that won’t go off.

repalced airbag…no change
replaces airbag ecu…no change

could it be the Digitek box under the dash ? And if buy a used on does it matter if I games from a car that the speedo is in km/h or miles/h ?

The airbag off key lock switch for turning off the passenger side airbag is a known issue. If the switch goes faulty then easy and cheap to replace. It will need a reset by sd2/sd3 or similar capable system as the fault code will remain regardless if the problem has been fixed without the computer reset.
 

Steve4200

Member
Messages
198
I finally resolved the soft suspension issue. Amazing how inept the dealer was. The problem was the ride height.
Now it’s just fine and very driveable.
I also replace the sway bars with FOrmula Dynamics and it’s much much better.
Another issue I have is the air bag light that won’t go off.

repalced airbag…no change
replaces airbag ecu…no change

could it be the Digitek box under the dash ? And if buy a used on does it matter if I games from a car that the speedo is in km/h or miles/h ?

It will not be the Digitek Bridge Can Dash Module. If you swap then it will be set km/h or miles as per the speedo type of the donor vehicle.

You will need to read the faults codes otherwise you will be replacing all parts unnecessarily and as mentioned in the previous post any fault on the Airbag system will need resetting even if faulty part is replaced / repaired.

Regards