ZAM400209
Member
- Messages
- 585
Could someone do me an intense favour? Or better, could a couple of you, do me an intense favour..?
I'm just reinstating the plastic fixing clips on my injector wiring loom mounting-studs, which hold both the vacuum lines across the OS side of the inlet manifold, (parallel to the OS fuel rail), and also the throttle cable down the NS side.
They've been off for a couple of years after I had the inlet manifold off a while back to change the starter motor.
Trouble is, upon refitting them, I'm not convinced it's right. Particularly on the OS- the three-finger vacuum 'holders' don't seem far enough down onto the M6 studs which come through the plastic tube holding the injector wiring. The Nyloc nut is barely catching the stud.
And the other side has these large diameter double clips which hold the throttle line to the cambox breather pipe (I think?) and I just can't workout where they all go.
I just want it OE and Internet photography doesn't go into enough detail. Can someone provide a big closeup of both sides of their inlet manifold please?
Thankyou in advance
I'm just reinstating the plastic fixing clips on my injector wiring loom mounting-studs, which hold both the vacuum lines across the OS side of the inlet manifold, (parallel to the OS fuel rail), and also the throttle cable down the NS side.
They've been off for a couple of years after I had the inlet manifold off a while back to change the starter motor.
Trouble is, upon refitting them, I'm not convinced it's right. Particularly on the OS- the three-finger vacuum 'holders' don't seem far enough down onto the M6 studs which come through the plastic tube holding the injector wiring. The Nyloc nut is barely catching the stud.
And the other side has these large diameter double clips which hold the throttle line to the cambox breather pipe (I think?) and I just can't workout where they all go.
I just want it OE and Internet photography doesn't go into enough detail. Can someone provide a big closeup of both sides of their inlet manifold please?
Thankyou in advance