Ian H
Member
- Messages
- 167
Hi
I am making steady progress with the 3200 engine rebuild and am just re attaching the gearbox.
The lever which moves the clutch release bearing (part 4 in diagram) has curved arms and I can't remember which way round it goes.
Should the arms curve forward towards the flywheel or backwards towards the gearbox?
Have had a look at parts diagram but is really not clear from that either.
The last picture shows a test fit with the arms curving backwards
Anyone know which way it goes or have a picture from the access panel at the base of the bell housing - bit stuck now with my Easter weekend project
Many thanks
Ian
I am making steady progress with the 3200 engine rebuild and am just re attaching the gearbox.
The lever which moves the clutch release bearing (part 4 in diagram) has curved arms and I can't remember which way round it goes.
Should the arms curve forward towards the flywheel or backwards towards the gearbox?
Have had a look at parts diagram but is really not clear from that either.
The last picture shows a test fit with the arms curving backwards
Anyone know which way it goes or have a picture from the access panel at the base of the bell housing - bit stuck now with my Easter weekend project
Many thanks
Ian
Attachments
Last edited: