Sam McGoo
Member
- Messages
- 1,789
Hey peeps,
I'm about to pull the plug on a quicklift/quickjack.
Has anyone got their GT in air at the moment?
I measured my GT lifting points some time ago and wrote down 1650mm front to back, but can't quite remember if that was to the hole centres or the outside edges to allow for lifting blocks.
Is anyone in a position to be able to check that for me at all? As I am away from the car for a couple of weeks and would like to get this ordered asap.
The Kwiklift KL2500HE states 1659 max and the QJ 5000TLX states 1676max so I want to be sure. Although the 17mm difference between the two (8.5mm each end) is minimal, so can't see it being make or break.
Thanks in advance.
I'm about to pull the plug on a quicklift/quickjack.
Has anyone got their GT in air at the moment?
I measured my GT lifting points some time ago and wrote down 1650mm front to back, but can't quite remember if that was to the hole centres or the outside edges to allow for lifting blocks.
Is anyone in a position to be able to check that for me at all? As I am away from the car for a couple of weeks and would like to get this ordered asap.
The Kwiklift KL2500HE states 1659 max and the QJ 5000TLX states 1676max so I want to be sure. Although the 17mm difference between the two (8.5mm each end) is minimal, so can't see it being make or break.
Thanks in advance.