Whats the Smallest ET youve seen?

Paul1982

New Member
Messages
91
Hi guys,

I've got a 4200 running standard 18" wheels. 8.5j et52 front and 9.5j et55 rear.

Now I'm looking at after market wheels but the ET (offset) are usually around 30 which means they will sit 25mm further out.

Has anyone pulled the arches on one of these to run different wheels before?

Any help would be grateful - thanks Paul
 

Spartacus

Member
Messages
3,188
i would nt alter your offset . it will bugger the handling and the steering geo. believe me i went through all of this with my alfa a couple of years ago . if the wheels were sitting too far "in" then you could always use a good quality wheel spacer. But if they are too far "out" then your stuffed.

id go for a recognized after market wheel . it will make life alot easier ;)
 

MAF260

Member
Messages
7,662
The one on the right...
NECA_12_INCH_FOAM_REPLICA_FIGURE_ET_01.jpg
 

MAF260

Member
Messages
7,662
You seem to be spending a lot of time thinking and talking about me, Benny. Stop flirting with me, it's never going to happen!