James3200GTA
Junior Member
- Messages
- 28
Hi,
So I started attacking all bits and bobs which needs doing on my 3200 including the Error light. I found one dead actuator and replaced that. Can confirm all 4 are rotating back and forth on key on. However the error light remains.
I found that the spindle on the left front was a bit sticky and may suffer from some corrosion on the spindle (hard to see). It also makes squeeky noises. First instinct is WD40, and that helped it along. It moves better better but not yet as smooth as the others. Two questions before running of to the specialist for a error code read out:
- Any other suggestions on getting the spindles moving more freely, besides a refurb on the shocks?
- Does anything else trigger the error light? I'm lacking user manual, so not sure whatelse can trigger the error light.
Thanks for your insights.
So I started attacking all bits and bobs which needs doing on my 3200 including the Error light. I found one dead actuator and replaced that. Can confirm all 4 are rotating back and forth on key on. However the error light remains.
I found that the spindle on the left front was a bit sticky and may suffer from some corrosion on the spindle (hard to see). It also makes squeeky noises. First instinct is WD40, and that helped it along. It moves better better but not yet as smooth as the others. Two questions before running of to the specialist for a error code read out:
- Any other suggestions on getting the spindles moving more freely, besides a refurb on the shocks?
- Does anything else trigger the error light? I'm lacking user manual, so not sure whatelse can trigger the error light.
Thanks for your insights.