Plastic part of soft top rear cover

[Cliff]

Hi, Is there anything that goes on top of the rear glove box over the three holes to support the centre of the plastic of the soft top cover as mine has sagged near the middle with getting hot in the sun I would think and no support there.
I have heated the plastic with a hair dryer and pushed it back quite a bit and glued a 13mm thick piece of rubber on top of the 3 holes. Iv looked all over the net to find a spyder hood cover open to see if there is anything there.

 

[Oishi]

I can't figure out what part you have there.
Here is what mine looks like:

 

[Cliff]

I can't figure out what part you have there.
Here is what mine looks like:
View attachment 87452

It’s the other side of the lid under the soft top cover. The soft top needs to be down and just open the cover and you will see it the other side

 

[conaero]

That’s the rear cubbybox upper cover, and no, nothing in top of it...well, not on the two I have here.

 

[Cliff]

There is still a drop in the middle as you can see in picture 1 so glued this in picture 2 just to support the middle