conaero
Forum Owner
- Messages
- 34,632
With semi retirement looming and the need to take on new challenges I am thinking of doing car restoration. Mechanical and trims I can do, even spray painting I recon I could do but the area I have no experiance is rust repair...cutting, fabricating panels and structure, welding in then finishing to a seamless finish.
I have a welder and have played with it on bits and pieces but would no way class myself as competent.
So what's the best way to learn and what kit do I need?
I have seen loads of car programs so understand in therory how it's done.
The reason I also need to do this is I am going to have my 69 Opel dipped and there will be loads of holes.
Upholstery is another area I would like to learn too.
I have a welder and have played with it on bits and pieces but would no way class myself as competent.
So what's the best way to learn and what kit do I need?
I have seen loads of car programs so understand in therory how it's done.
The reason I also need to do this is I am going to have my 69 Opel dipped and there will be loads of holes.
Upholstery is another area I would like to learn too.