Dashboard error indication.

Skid1769

Junior Member
Messages
176
Good Morning everyone and a Happy New Year to you all.
New year and a new problem on my 3200 GTA. I have had an error indication on my instrument panel, had it checked out by my local independent expert who found out I had a sticking shock absorber, this has now been rectified but the error message remains, we have put his good actuator on the top of each shock so we know they all work. Can anyone suggest any possible theories regarding my way ahead..???

If not, then my next point of call will be to take the car to Arrow Cardiff to get them to plug it in. Anyone used them yet??

Thanks in advance for any help anyone can offer.

Cheers

Stuart
 

rs48635

Member
Messages
3,181
Try battery reset.
Ensure your radio code is known
swithc isolator / disconnect battery.
Wait 5 minutes
re-connect.
wait 10 minutes for car to calm down.

Execute throttle pot re-calibrate routine (search here)

Start upo and go for a spirited drive!
 

Contigo

Sponsor
Messages
18,376
If ERROR is lit then there must be a suspension fault, either a borked shock or a faulty actuator.
 

allandwf

Member
Messages
11,000
Are all four of the motors on top of each shock ok? It will drive them as part of it's pre start checks if they are ok the light should go out. If one is sticky the "ERROR" light will come on.
 

Contigo

Sponsor
Messages
18,376
Correct, you can listen to each one with stethoscope or screwdriver and tell if one is not clicking which is the noise the make during this self test procedure. Heat from turbos makes them intermittent too.