They are NLA - no long available. 4200 spares dwindling with more and more NLA
This is possibly the best solution. They are a small part that could easily be scanned in and built.Is there an opportunity for someone with a 3d printer to help out long term, assuming one can be found for a pattern?
Sopranostu has a couple of washers with covers on ebay. Not sure if they are both lhs, but he may split washer and cover if he has a right hand oneJust a bump. Still looking for a RH one, any that were/are available on ebay, etc seem to be LH. RH is indeed NLA and apparently rarer than rocking horse droppings.
I have actually bought a new LH one from Eurospares, so if a RH one can be located I could look at getting both scanned for future 3D print or possibly lend to someone else on here who has the ability to do this. Or can you flip the 3D scan?
The other option is to cut the plastic lugs off and make new ones, to get the LH one to fit. It appears on a quick check that it would flip round...but given the cost of such a small part I am loathe to do that just yet!
Yes, the scan can be flipped...Just a bump. Still looking for a RH one, any that were/are available on ebay, etc seem to be LH. RH is indeed NLA and apparently rarer than rocking horse droppings.
I have actually bought a new LH one from Eurospares, so if a RH one can be located I could look at getting both scanned for future 3D print or possibly lend to someone else on here who has the ability to do this. Or can you flip the 3D scan?
The other option is to cut the plastic lugs off and make new ones, to get the LH one to fit. It appears on a quick check that it would flip round...but given the cost of such a small part I am loathe to do that just yet!
Thanks for that. It’s surprising that as so many seem to come off and be lost that they haven’t kept some in stock. Obviously a bad design here....Not sure if my broken one which Matt and Ashley replaced last summer is still in their shop... could be used as a basis for a scan... not sure where it was broken though.