GranTurmiso Sport jack pads

Pierre A

Pierre A

Junior Member
Messages
32
I’m looking for an after market rubber jack pads for my GTS. To be honest I’ve never had to jack up my car. On two occasions I’ve had it flat bed towed to the dealership. I’m planning on changing my brake pads and wanted to know what other Maserati folks are using to Jack up their cars not using the factory scissor jack?
This is what I found but it’s made for a Tesla 3. Looks like it might work?
 

Attachments

  • 6708505D-06DC-4A75-9BB2-4FF32F0D9B9F.png
    6708505D-06DC-4A75-9BB2-4FF32F0D9B9F.png
    1.5 MB · Views: 26
dunnah01

dunnah01

Member
Messages
648
A piece of wood is just as good - pnnarr
Those pads are universal fit so would also work if you have enough ground clearance with your jack. At worst you would need to cut off the sticky up bit.
 
Zep

Zep

Moderator
Messages
9,232
I looked at those but thought the pin in the centre was a bit too big. Worth a punt though, my car is hibernating but I will be sorting something out this year.
 
Sam McGoo

Sam McGoo

Member
Messages
1,760
They look like they would work. As said above, if they didn't you could just cut off or 'turn' the stick up to the right size.

I always use Ice hockey pucks. Basically the same as what you posted without the stick up. I've used them for years and never had one split, move or damage a car.
A pack of 10 can be had for around a tenner.
 
midlifecrisis

midlifecrisis

Member
Messages
16,189
philw696

philw696

Member
Messages
25,377
Zep said:
I looked at those but thought the pin in the centre was a bit too big. Worth a punt though, my car is hibernating but I will be sorting something out this year.
Click to expand...
Always turn them down in a Lathe it would take no time at all.
 
  • Like
Reactions: Zep
eight

eight

Junior Member
Messages
94
Just to confirm, the sick squid Tesla pads fit spot on. Surprisingly well made, very tough rubber that will take the weight fine. Knob fits in hole ok, and the pads are thick enough to bring the jacking point level with the outer sills.
This product gets the tight-wad Seal of Approval.
 
Lavazza

Lavazza

Member
Messages
1,060
eight said:
Just to confirm, the sick squid Tesla pads fit spot on. Surprisingly well made, very tough rubber that will take the weight fine. Knob fits in hole ok, and the pads are thick enough to bring the jacking point level with the outer sills.
This product gets the tight-wad Seal of Approval.
Click to expand...
I can't find any for sale.
 
StuartW

StuartW

Member
Messages
9,314
ChrisQP09 said:
Does anyone have a underside picture of a GT showing the exact jack points? For axle stands.
Click to expand...

You certainly have to be certain that you are supporting the car in the correct place - I'm sure that someone will be along shortly with the appropriate photos
 
ChrisQP09

ChrisQP09

Member
Messages
2,996
StuartW said:
You certainly have to be certain that you are supporting the car in the correct place - I'm sure that someone will be along shortly with the appropriate photos
Click to expand...
I guess your trofeo has air jacks makes life a little easier i would say
 
You must log in or register to reply here.