Search results

The title says it all, car is up for sale and I noticed that the front n/s seems to be sitting lower than the other Side (2 fingers verses 3 on the good side.). Car up on ramp and guess what the f/n/s shock is weeping. As it’s for sale I don’t want to spend a whole pile of money so would a...

I have a vertical acceleration sensor to go into the r/ns of the masser. Does anyone have any knowledge of the boot strip down required. Also are there any specialist trim tools that I would need? Thanks Neil

Hello all, 2003 4200, 51000mls with some history. Owned by me for 2yrs. Second hand clutch from eurospares with 15% use and thrust bearing fitted last year And pis sorted. New rear discs fitted 1mth ago along with pads. Front discs in excellent condition. New front wheel bearing from...

Hello all, I am in need of a set of hub centric spacers for the rear of my 4200 preferably 20mm or above. I already have the fronts(15mm). I fully expect to be slagged off for this but I just love the way they look on the car. Ttfn, neil

Don’t know if this has been mentioned but in the new Batman film (superb by the way), the penguin drives a quattroporte. Great advertising, seeing the duffing it takes. Mind you the batmans ride with supercharger whine and lovely gearbox/ transmission noise really done it for me, especially as...

Hey all will the single belt tensioner pulley from a qp fit my 4200? I see on scuderia that for the qp there are two different part nos for the same pulley. One of the part nos is a match for mine, however on eBay the other part no is being shown instead. Are these the same thing? Thanks...

As the title says, I’m in need of a front wheel bearing for the masser. Can anyone point me in the right direction please? Thanks very much neil

Hello all. I have an 03 4200. I slammed the drivers door shut a bit too forcefully and the protective speaker mesh popped off. On looking at the speaker I was very surprised to see quite a few large holes in the paper element. My question is this : does anyone know of a direct replacement...

So today I received my 4200 back from getting a new clutch. The guy who done it hadn’t got the relevant software to reset the pis so I contacted main dealer Charles hurst in n.I where I live. To reset the pis needed 2hrs labour possibly going into 3hrs. Surely this cannot be right or am I...

Hey all, my 4200 drivers side window regulator has give up the ghost making a really unhealthy noise at fully open. It then wouldn’t shut and made an even unhealthier noise At the same time. Door card off and window put back up. It still does the partial opening on getting in and out of the...

So I went to have the tow and camber done on my 4200. The alignment place wouldn’t touch it as they said there was coil overs on the car and that they were screwed up so far that the spring wasn’t able to do it’s job (rears). I wondered why the ride was so firm on coming down from a bump. My...

Hi, I have a black 4200 (the one that Dwight York used to own, but don’t hold that against me) . The leather has been treated to a partial renovation that hasn’t been done very well. I want to finish the job but don’t know the colour designation. I just thought it was cream so recoloured the...