Search results

Had this issue, managed a fix in situ replaced it and the one on heat exchanger with silicon pipe.. hasn’t gone bang or leaked so all good.

I'm sure everyone doesn't mind you taking your time with this, appreciate the work so far..

Burgandy Quatroporte in Brecon.. Now I've seen the colour in person not bad..

Honestly, I've been looking at anodising the ones I'm gonna order when your ready.. so yeah black would be my choice, but ill go with the majority.

4 for me also please ta x

Ta.. might keep it like that, I’m several thousand miles from my car but back in a few weeks to see it proper.. will see..

So had my wheels refurbed as were a tad kerbed, went for a colour change, but now the bolts stick out a bit.. no idea measurements to see if i can order ones in black, but might get plastic covers for them.. any one tell me the size of the bolt head as ill make do with covers if they look good...

Yeah, I need to order from them for my bonnet struts, holding it open with my head gets tedious after a while.

Yeah I’d be up for this if your doing a list for those that bought the original stuff count me in thanks.

Dear god thank you, only wanted to change the clock and now I’m happy..

Mine went through fine this year, only advisories were front n rear break discs which were worn, at least they are cheap to buy right best save for those then..

Yeah was a pain, I’ll assume if you went to Maserati to do they would take the gearbox off, which in all honesty would have been easier, but I have no access to anything like that. Also blue was because I didn’t select any other colour cause lazy.

96k mine has done, so not bad I suppose. Also replaced a pipe that feeds into heat exchanger as one of the clamps was loose, no idea what it does but while i was there n all.

So, that is a ******* to squeeze in.. All done tho, so it is doable.. I have some pipe left over if anyone needs.

Dropping things at work would imply I work.. managed to gain access to pipe.. ooh that’s tight.. but I can see the split so at least it ain’t apart for nothing. tomorrow’s job tho...

Lol, I have something similar, just didn't use it cause, well I dunno, excited/lazy want my car to run again quicker.. Did use it to recover clip under car tho.

Thanks, wasn't sure, was gonna do that if there wasn't a specific setting. So far I have enough off it isnt any of the coolant pipes I can see, only one left is the one on back. On a side note injector electrical clips were fun pinged one of the clips into the depths of the engine bay, ended...

So, long story.. Car temp shot up alarm beeped, and I pulled over in a cloud of steam.. Seems the ******* pipe on back of engine has gone pop.. atleast I believe so, in middle of taking apart (so much plastic!) Anyhoo for putting back together when hopefully I can reach and replace rubber...

looking at no 4 on this diagram says there are 23 of them, seem to be all the same size.. https://www.scuderiacarparts.com/en-gb/part-finder/maserati/granturismo/oe/71/3695/65305?h=200612 I will play guinea pig, gonna take em off n measure them all on mine, cause I’m sure the last time I had...

You guys mean the torx bolts ? And now I’ve looked at the part no.. yes.. Im sure I’ve seen a thread that says they are M5 x 16.. in which case loads of ss ones around. mind you titanium ones here. https://www.ebay.co.uk/itm/184033193301