Search results

4.7 S any use? Might chop mine in with values being high

I always crank it for 2 seconds, and turn it off just at it goes to start. Then i'll run the engine

Who will modify the caps?

Gotcha - just looking for the valves as going to do mine Sorry for the bump!

Be great if we could watch online

Any links please to the oil control valves people are fitting in the caps?

Posting links to other cars with the same name but not the same spec engine wise is just daft

Ah good news

Ah glad it's sorted Bottom hose much money?

On my 4.7 the sensor fitted on the left hand side was leaking New seal sorted it. Cost pence. Hose clips also looked poor and thin Found two small drips and nipped them up

Subframe time now where the pipe overs fit Terrible water trap. Cup wire brush in the grinder soon cleans then up and then rust treatment then a zink coat then stone chip. Bloody car.

Stone chip is great but you need to deal with the issues underneath first

Diesel? No thanks

Blasted. Then zink primer and 2 coats stone chip. Done.

Ordered me a pair for my 2010 QP 4.7. As for bolts. Will be a few pence for zinc coated ones.

Cheap, yes. Bad news though. None in stock now. Had mine from the states.

Time to strip the bumper off Just swapped mine Factory stuff is rubish. It's glued on.

I'd expect better. Shame. Almost spoils the car.