Search results

I'm certainly not looking for a profit ! So, is anyone interested -PM me?

Hi all. I've decided to sell my beloved GS. I therefore have a set of 4 group buy disks and a selspeed pump surplus to requirements. Any offers? PM me.

Had my GS headlight switch go bad due to internal corrosion. The Maserati part is expensive/hard to find but you can rebuild it with internals from : ALFA ROMEO 166 LUSSO T SPARK HEADLIGHT HEADLAMP SWITCH 156434500 for 1/10 of the cost.

A crack can be rewelded at a specialist... I also gave up on Pzeros and went to PS4s.

Well I got the alternator going by waggling the alternator connector -but there was never a charging light warning. The dipped headlights are not working now but the beep beep has stopped and the tail lights are off. At this point the local euro car rescue has carried us to a hotel and euro...

I'm stopped in Italy with an almost flat battery belt ok all systems seem to work except headlights. Is there a fuse or relay that controls charging

Sounds about right. CHeers

Isn't the current bid a steal for the parts value? If I had the space I'd buy it and break it slowly for parts...

You could put some dehumidifying crystals inside with the doors closed -especially if the garage gets cold and damp. (Also lube the door seals with rubber protectant). Watch out for mice... Cheers PS It looks very shiny!

No need to disconnect, the 4200 has a master off switch which isolates the battery. Charging at 2 amps will take a long time. A good 5 amp lead acid charger should be fine -it is for me anyway... Cheers

I think you' ve forgotten traffic density. As the cars slow the distance between them closes (or it should) which offsets the reduction in speed...

Was there a solution to the problem in the end? Or is there a link to another thread? Like to know thanks.

Me too but not had a reply to my pm... Cheers

Well TTX is Fugu poison and M8 is mate. So I guess you could use it as a good plate to warn someone??? HTH

Hi Bruce the car has 27k miles. I must admit that shine came from a professional detail that used synthetic polishes and waxes -but I can't say what they were. The paint has few scratches/swirls so it comes up well when I do a gentle polish (Autoglym) and spray wet look detailer (Maquire). You...

If heat treated properly, a weld can be as strong as a casting -as far as I know. Don't think your average welding shop will research and apply the correct pre and post heat treatment for welding Mg and Al alloys tho'. It seems clear (IMO) that this is a serious casting defect -it would have...

Hi All Had a strange fault with the parking car lights, they would not switch off -the parking lights came on overnight while on holiday and simply refused to switch off. Turns out there was some water inside the light switch body which can be taken apart with a very small X head screwdriver...

While we are talking tyres, has any one changed the size/profile to help minimise pothole damage? On the US side, they've talked about increasing width by 10 front and rear which with the same profile gives a bit more sidewall. Would increasing the profile help? I've had two cracked rims in...

Thanks too Safrane! M

Money sent Hi I've sent the 118.79. Re. fees, I will send that as soon as you've worked out the charge... Thanks M