I remove the buttons and ground the outside edges of each button with Dremell. I think the casing and buttons are made of different plastics! Regards Mark
Sent from my iPhone using Tapatalk
Hi Guys, just wanted to let you know about a problem with the crank sensor on my 3200 that I have now resolved. Since buying the car it would not start from normal operating temp unless I left it switched off for 5-10 minutes. After fitting 2 new crank sensors I found the problem was the...
Hi Guys, I am thinking of upgrading my throttle body to contact less but unsure who can provide the best solution if anyone can give their views on this. I also wonder if I should replace the pedal pot for contact less at the same time, again who could supply the best solution. At the moment I...