Sorry, but the Eurospares diagramm says on both sensors suitable for cars with skyhook suspension.... I have to check mine wether I have both of them. No2 for sure.
My car was in the workshop and they filled 800g was the feedback.
When the AC was not working I had the feeling the AC compressor tries to engage. It was like on and off...also the rpm where rising and coming down again.
So the easiest way for me at the moment would be to exchange the...
I have a skyhook suspension since I have the wire coming out of the shock.
But I also have No2. The picture of the sensor is out of my car.
So now I‘m completly confused
With every reply I got more confused :D
So eurospares says No.2 is a accerelation sensor. The actual accerelation sensor on the car has a label with "vertical" on it. So that´s why I´m confused.
@conaero
You are also mentioning vertical acceleration sensor. So No. 3 or 2?
it´s btw. PN 264470...
I have a Skyhook Error Message on the Dash.
I scanned my Grancabrio with the Launch X431 and it gave me the code C1022 Acceleration Sensor LH Front Wheel.
So looking at the diagramm at Eurospares here it should be No.2, right?
But as I checked the sensor of the diagramm with the sensor in...
I have the same code/issue.
Sometimes the AC does work, sometimes not.
I was googling the fault code and came across this thread. Nearly ordered right away a ne pressostat.
But I also saw this video where it was this Fan Resistor with the same error code.
Since I have it as spare already...
Yes, think so too.
But if could be taken off and sold seperatly, there is also a possibility to buy the sensorring aftermarket as new and exchange them and not the whole assembly.
uuuuuff, the bearing is around 900 shipped. And the car has 4 of them. I asking myself when the other will fail.... Crazy there is now aftermarket solution!
I checked today the live data. The sensor is working and I had readings from it, but when I´m driving constantly the sensor show...
I´m having an issue with the top cover of my Grancabrio.
After opening the left latch is not pulling the cover flush with the car body.
It seems the latch is working properly, because when I close the roof again the left side is identical with the right side, so flush.
I will attach pictures...