Thanks Loz, eurospares do them for £20 used which is a bargain. Just wondering if i need to hunt down an actuator whilst i'm at it. I'll get the spring and see what happens i think
Ive been having a poke around under my 3200 today and noticed half a coil has snapped off the bottom of the drivers front coil spring. Would this be the cause of my dash error light or is it more likely to be a faulty actuator?
thanks ...leigh
oops, didnt see the link, cheers Matt. This could well be my problem. My pads were stuck fast and i did have to remove all 4 calipers to remove the pads. I also needed to grind the new pads in to make them fit. I put this down to the cheap pads i fitted to get me through my MOT. At least i plan...
im scared to remove the backboxes as one in particular is very rusty. The only thing putting me off with the RPI pipes is the single exit. I love the look of the 4 tailpipes
Has anyone tried the rpi straight through rear pipes on the 3200? I noticed my backboxes were looking a little worse for wear when it was up on the ramps today and thought this may be an economic solution?
i used bosch wipers from dbay for around a tenner and they are great although i did notice on eurospares that the maserati ones were only around £17 after i bought them
Also, where is the vaccuum source for the servo taken from? I followed the main vac line from the servo and it runs along the bulkhead of the car into a non return valve and into the passenger side airfilter housing?? Surely there isnt enough of a vac source here????
Need a bit of advice here. Brakes have never been great on my 3200 since ive owned it. Ive had it off the road for the past 6 months and am getting it ready for its MOT tomorrow. Put new pads in today all round and changed brake fluid and all bled through. Brakes are still very bad. I really...
Been getting my car sorted out for its MOT today and was looking at the shocks. They have a height adjustable spring seat and are bilsteins. Do these sound like they are standard shocks? They still have the ferrari actuators on top
Leigh
i thought the only difference in the bonnet was the vents? i just assumed they would be interchangeable. i have parked next to a 4200 and to my eye, they didnt look too dissimilar at all
if i have to buy new, of course i will. Im all for members helping one another out. I reckon with my mate doing the MOT and a bit of adjustment i might just be able to hang on for the set already in circulation though. if i have time, i'll have a quick look tomorrow