ledlights
Junior Member
- Messages
- 189
Al,
The unidiag software allows you to specify the com port on the settings page but the interface electronics are not powered up until you plug the iso in and connect the red supply wire to the +ve battery terminal. So I suspect that's why you're not seeing anything on the screen.
The thing that took the time for me was finding the correct iso for the ECU - it's the grey one hidden behind the carpet on the RHS of the driver's footwell.
Good luck,
Steve
The unidiag software allows you to specify the com port on the settings page but the interface electronics are not powered up until you plug the iso in and connect the red supply wire to the +ve battery terminal. So I suspect that's why you're not seeing anything on the screen.
The thing that took the time for me was finding the correct iso for the ECU - it's the grey one hidden behind the carpet on the RHS of the driver's footwell.
Good luck,
Steve