Results 1 to 6 of 6

Thread: 3200GT Fuel Filter replacement

  1. #1
    Senior Member RossWA's Avatar
    Join Date
    Jul 2011
    Location
    Western Australia
    Posts
    135
    Hi Guys,
    Some advice on replacing the fuel filter please.
    Are there any special instructions or tools required to undo the connections to the fuel filter?
    I can see at the top there is an inlet fitting that appears to be plastic? do I remove that first or just undo the fitting below that connects to the filter?
    Thanks
    Ross
    Attached Images Attached Images
    2001 3200GTA, 1999 Alfa 166 3.0
    Previously: Shelby 427SC replica, Alfa 164, Alfa 75, Alfa Giulietta, Alfetta GTV

  2. #2
    Senior Member SteveM's Avatar
    Join Date
    Jan 2011
    Location
    Bath
    Posts
    317
    From memory you squeeze the plastic fitting and it just pops off. Leave brass fitting in filter. At other end undue nut nearest pipe but again leave brass fitting in filter. Shouldn’t be too much petrol leakage but worth putting rags below. You only need to loosen bracket not remove entirely and filter can then be slid out.
    Once filter out you need to swap brass connectors onto new filter making sure you match flow and outlet arrows to old filter.
    I put old filter in vice and spanner on filter hex shape and then used spanner to undo brass fittings. You will realise why this isn’t an instu job to remove and swap brass fittings
    Good luck
    Ps don’t forget to depressurise system using valves on each fuel rail.

  3. #3
    Senior Member RossWA's Avatar
    Join Date
    Jul 2011
    Location
    Western Australia
    Posts
    135
    Thank's for the advice Steve,
    I did not think about depressurizing the system first, that could have been a surprise I did not want!
    Ross
    2001 3200GTA, 1999 Alfa 166 3.0
    Previously: Shelby 427SC replica, Alfa 164, Alfa 75, Alfa Giulietta, Alfetta GTV

  4. #4
    Senior Member davy83's Avatar
    Join Date
    Aug 2010
    Location
    Newmachar, Aberdeen
    Posts
    1662
    What he said, and yes de-pressurise, I found out the hard way, doooh.
    Current - 3200 GTA, Yeti, V8 Land cruiser,
    Previous cars - TVR Chimeara 4.5HO, TVR S2, 5.0l Mustang, Jag XJ, racing Hillman Imp.

  5. #5
    Senior Member madmanmart's Avatar
    Join Date
    Sep 2014
    Location
    Staffordshire
    Posts
    157
    While you’re in the boot, check the fuel pumps over.

  6. #6
    I wish I'd asked first - got a puddle of petrol in the boot!
    Steve.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •