Finally got round to addressing the hunting / air leaks.
There were leaks from;
The plate on the bottom of the manifold - the shoe lace gasket was about 1mm too short and you could see where it was coming out of one corner.
Around the throttle body.
The manual says you are supposed to "glue" the gasket on, but the new McGrath ones are tricky to get to fit. I used some flexible gasket round the edge to seal any gaps.
There is still a small one from one of the three bolts that hold it on but a quick dab of gasket should fix that.
I did manage to snap the last of the black screw in unions in the back of the manifold !!!
Quick email to David Askew and he is sending me one of the brass 3200 ones, which i plan on fitting with the manifold in place.....
Might drive it this weekend !!
There were leaks from;
The plate on the bottom of the manifold - the shoe lace gasket was about 1mm too short and you could see where it was coming out of one corner.
Around the throttle body.
The manual says you are supposed to "glue" the gasket on, but the new McGrath ones are tricky to get to fit. I used some flexible gasket round the edge to seal any gaps.
There is still a small one from one of the three bolts that hold it on but a quick dab of gasket should fix that.
I did manage to snap the last of the black screw in unions in the back of the manifold !!!
Quick email to David Askew and he is sending me one of the brass 3200 ones, which i plan on fitting with the manifold in place.....
Might drive it this weekend !!