Search results

Greetings, welcome. Very nice indeed. Have you run into KJB for parts at anytime? If not, there's a thread here which may be of interest.

Is that a carbon fiber codpiece?

Put some on a sponge and leave it under a seat or dash.

Not that I know of.

It is for a 3200/4200/GS but only those fitted with this type of fuel filler neck: Not this type: Would the vendor take it back rather than taking a hit on eBay?

Maybe of interest: Google "spec.dock Bentley Continental GT v2 Installation Instructions" The .pdf guide doesn't appear to involve seat removal. Trim removal looks simple enough - then they are wanting to sell something so I suppose it would do.

The yellow connector is TE .070 Multilock and I'd imagine those at the other end are too. White connectors are still available but not sure about yellow. If not, to retain originality, perhaps recycle the connector(s) - crimp removal tools are sharp sods though.

Taking care not to crush an EV pipe against the rear cross member.

Maybe an improvement :smile:

Be more dog...

Still do, most types, although stopped getting KP a few years ago when their allergy warning stated "may contain peanuts". Thought "f?** me, that was a close call".

You're quite close to Autoshield in Manchester I believe? Marios is regarded by many as "the" expert in setting up a CC box.

You'll need diagnostics to set PIS & clutch config table. Maybe of use to you/your garage to read/view: http://craig-waterman.com/?p=286 Plus a couple of videos - bearing release touched on in the 2nd part:

You're quite right - but don't call me Shirley :smile:

Can't find anything either although, admittedly, haven't looked too hard. A DfT paper from 2010 states aftermarket HID headlamps are required to comply with ECE Regulation 48. Which "in practise" means headlamp cleaning and self-levelling are required. Would OEM Xenon be classified as...

Bit precious - doesn't sound like you. Having a bad day or has one the forum bods been in touch?

Did you have the audio files on the chip at the time of the update? That might well have been the issue. That's in the manual too :lol2:

Having been warned off the 8180 (by the firm that Kenwood use) I've the unit that precedes it. Basically the same without the carplay interface. Alright, it wasn't obvious but it's there - re: usb requirements. I was wondering why an excessively large music drive wasn't recognised :smile:

If you haven't something similar on the wall already maybe of interest...

Simple one to add but NLA from Maserati - part # 208041 is shared with an Alfa 166. Outer mirror switch for GS & later 4200s with the cup holder mounting plate: Nb - early 4200s use a different shape switch. Part # 3833300136.