Search results

:) very nice

sounds good :)

Hi guys - this has just failed on the MOT & I have sourced a new one, but Im just wondering if anyone on here has had to replace one before and is it a easy job? Two or three bolts and a cable release ? Cheers :)

Thanks :)

Cheers for all the info - its booked in to get checked out :)

Im looking out for a oil pressure gauge first to see if that is the problem - as it started behaving herself last night, but still bouncing around. Ive also seen it can be down to a bad earth - if thats right or wrong.

Thanks for your answers guys - :) I'll get her booked in.

Thanks for the info - its an auto box :)

I have to say that I did forget to ask him for the part...but he said that it has been replaced.

In neutral - handbrake on - the pressure shows 2 bar - lit oil pressure lights

I believe that the grade of oil used looking at the receipt was fully synthetic 10w 60 motor oil. This latest garage said they checked the wire which joined to the sensor (approx 3 inches and it seemed ok)...but they dont know what its like around the turbo without taking the turbo out...

Hi guys, After taking the Mas in for a works carfest (beautiful hot and sunny day and LOADs of lovely vehicles) and then a rapid drive home, the oil light popped up on the dash and I noticed that the oil pressure gauge had dropped down to 2 bar (with that round red warning light) on as well...

Free day on Sunday so might well head on over then :)

I will do :)

A bit of spare time...just to play with the photograph :)

Bristol......:)

:)

Masers corner it is next time then :) First time attending - lovely selection of vehicles.

Very good to have met you chaps today - It was an early start firstly at the breakfast meet in Bristol - a couple of 4200s and 3200's noted...and then a brisk drive down to Newbury.....Even better winning a couple of the prizes :) :) and then back home. See you all again :)

Tidy :)