Recent content by andy15

  1. andy15

    Transmission Oil

    That's right. Should have mentioned that. I use that one for 3200 automatic. Wysłane z mojego motorola one vision przy użyciu Tapatalka
  2. andy15

    Transmission Oil

    ATF DEXRON III Tutela GI/E by Petronas Wysłane z mojego motorola one vision przy użyciu Tapatalka
  3. andy15

    Throttle body 3200 P0221

    It is contactless already. If that is the problem, it will be electronics. Mechanically it looks fine.
  4. andy15

    Throttle body 3200 P0221

    When driving it doesn't looks that bad. And what's important, after throttle body got cleaned, the P0221 never came back, so that's a big improvement already.[emoji3]. As I mentioned earlier, both non return valves on the oil vapour recovery system are removed, what do you think about that...
  5. andy15

    Throttle body 3200 P0221

    I didn't yet, but when connected trough eobd, I'm getting similar results. The sensor will be next to check. Not sure how to yet, but will figure out something. Wysłane z mojego motorola one vision przy użyciu Tapatalka
  6. andy15

    Throttle body 3200 P0221

    Just did some tests again and with the PP disconnected it's still a bit low and the throttle butterfly keeps moving slightly. The speed sensor does make a sense. I will go this track now. I made a video with the PP output voltage (white and yellow connected) and the revs gauge. Holding the pedal...
  7. andy15

    Throttle body 3200 P0221

    This is a standard one. I am aware of that and not too keen to do it as well, but it will be for a test purpose only. I wouldn't be too happy driving it all the time like that. The car can be scary enough without that mod :D.
  8. andy15

    Throttle body 3200 P0221

    Thanks Contigo The vacuum leaks were all checked and repaired when I had the manifold out. Turbo hoses checked too :) The rest voltage is 450mV, so within the range. I will measure again with white and yellow connected. I guess this will give the higher value of the 2 output values. I'm also...
  9. andy15

    Throttle body 3200 P0221

    It took me a while, but I have some more info and more queries too. The TB has been cleaned, lots of metalic powder removed from the magnet in side the step motor. After I've done that, I did pedal reset and the P0221 never came back. So now the suspect is the pedal pot. I measured the voltage...
  10. andy15

    3200, no fans and running too hot

    In regards to the heads and gaskets condition I suppose it's worth to do a compression test. Wysłane z mojego motorola one vision przy użyciu Tapatalka
  11. andy15

    Throttle body 3200 P0221

    Wow, ECU??? that doesn't sound good at all. :ohh: Have a look at the video. I would say it's quite steady, but still goes up and down a bit. https://drive.google.com/open?id=1PnmZTTbFcKK_GDRAO33O1nuL_7YZB6Ef
  12. andy15

    Throttle body 3200 P0221

    ...Magic mushrooms :rofl5::saifi4: Thanks davy83 When it starts it looks fine, doesn't go anywhere high, and stays at 800 (when is warmed up). What I mean by not holding steady revs I mean that when it runs on 800, let's say, and I want to increase the throttle a bit to set at 1800 it will go...
  13. andy15

    Throttle body 3200 P0221

    0.015v- that's a bit tight. Not sure if was it that close... Will need to check again. And maybe should I connect 2 outputs together, just for a test? Also didn't mention that earlier, but the car can't hold steady revs in range, c.a. 1300-2500 rpm. Any idea with that?
  14. andy15

    Throttle body 3200 P0221

    Thanks Oneball. I will definitely get this checked with opening the throttle. I did the video good few weeks ago, so don't actually remember if was it moving. The voltage I did checked on open, closed and at few points in the middle and was OK. First I had 2 multi-meters connected and then I...
  15. andy15

    Throttle body 3200 P0221

    I am getting the P0221 code more and more often recently. (Throttle/Pedal Position Sensor / Switch "B" Circuit Range / Performance) The TB has has been refurbished to contact-less, but as it was done before I owned the car, I have no idea who did it and how. Initially I suspected the PP, so...