Contigo
Sponsor
- Messages
- 18,376
Excellent deal! I assume your testing swapping discs between NITs were successful
Well done!
C
Oh yes all confirmed, tweaks have to be made to the image files but extensive testing has been worthwhile.
Excellent deal! I assume your testing swapping discs between NITs were successful
Well done!
C
Oh yes all confirmed, tweaks have to be made to the image files but extensive testing has been worthwhile.
No, the one I used didn’t. It’s worth a shot but I prefer spinning disk.
You seem to be able to get them for a £2-300 or so, cheaper to get the cable separately, presuming that is my current issue. Could be useful for other spare parts people needed in the future though
I've attached a few more photos, to be honest I'm struggling with the continuity checking, the connectors are very small! Some pins seem to be working, others not. As for moving it there is a little room but I wouldn't know where to start!
View attachment 39365View attachment 39366View attachment 39367View attachment 39368
Thank you for your assistance I certainly appreciate your help. The slave and master jumper is not necessary according to the earlier post. I was instructed to break off the last two sets of pins where the jumpers would normally go in order to make the hard drive fit. So I reformatted the drive to fat32 and mounted the image file onto the drive with identical partition as the old drive. Now the head unit turns on but gets stuck on the Maserati logo. I tried disconnecting the battery to reset the ECU to see if it would fix the problem but unfortunately, it did not.